现在我们的生活中随处可见各种各样的环氧地坪，比如地下车库，生产车间，球场等等。但是在施工结束之后，有时候会发现环氧地坪表面不平整，有杂物，看起来不美观。可能好多朋友不知道为什么会引起这种现象，下面简单给大家分析一下导致环氧地坪表面不平整的原因。

Now we can see all kinds of floors everywhere in our life, such as underground garage, production workshop, stadium and so on. But after the construction, sometimes the surface of the epoxy floor is uneven, there are debris, and it looks ugly. Maybe many friends don't know why it causes this phenomenon. Here's a brief analysis of the reasons for the uneven surface of epoxy flooring.

1）施工中杂质混入；

1) impurity in construction.

2）地面不平整，起伏过大或施作环氧地坪规格太薄；

2) uneven surface, undulating or too thin floor.

3）材料涂布时，已部分反应，粘度过大，甚至产生硬块；

3) when the material is coated, it has been partially reacted, the viscosity is too large, and even the hard lump is formed.

4）施工中断料，来不及衔接。

4) construction interruption is too late to connect.

其实这些状况经常会出现，只要我们找出原因，对症下药就行，主要有一下几点解决方法：

In fact, these situations often occur. As long as we find out the reasons, we can prescribe the right medicine. There are several main solutions:

1）环境力求清洁，石英砂应选择颗粒均匀者；

1) environment should be clean and quartz sand should be evenly distributed.

2）地面处理平坦，并清洁干净，凹处须修补，附着物须铲除，依实际情况选做适当规格地坪；

2) The ground treatment is flat and clean, the concave areas need to be repaired, the attachments need to be removed, and the floor with appropriate specifications should be selected according to the actual situation.

3）材料前后涂布，须在可使用时间衔接完毕。以免超过使用时间，材料粘度过大而无法自然流平，或桶内残存部份涂料产生少许硬块，此时应更换新桶。

3) before and after coating, the material must be connected at the time of use. In order to avoid excessive use time, material viscosity is too large to flow naturally, or the residual paint in the barrel produces a little hardness, at this time, the new barrel should be replaced.